Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sakthisithardhan
Calibration is the process of to set an instrument to show
the reading in between allowable scale....
example 0-10V meter
if ponter shows <0 means v've to calibrate it to show exact
0.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
what is SIL 1 2 3
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.
what are the different types of Protocols? & their applications.
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
How to Calibrate Vortex Flow transmitter in field
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
How hart protocol can be connected with control valves?
What is the use of double seated valve?
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
how to design orifice plate?what is the equation?
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
