what the purpose of protection signaling equipment in
substation?
- 2 Answers
- 8287 Views
- I also Faced
- E-Mail Answers
Answer Posted / dinesh
Protection signal(Pulse) helps to act the relay to trip
and disconnect the equipment from the damage,
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
how to select overload-relay for perticular motor 1.for D.O.L. starter 2. for Star-delta starter ????
what kind of technical test that i need to learn because i have an interview tomorrow.. please someone help me..
can any one tell in easy method for circulating current ??
How line capacitance & line inductance varies with increase in height tower.
how to calculate the lightning arrester conductor @ no of earth pits required
How to select the proper VSD to operate high inertial load
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
List examples of voltage source?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
Explain about retrofitting of machine tool.
What are the functions of temperature scanner in power transformer?
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
How Diesel Generator start ?
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
