Answer Posted / harish - greenesol
actually for plc and for electronic systems we usually
supply in mamps. GENERALLLY FROM TRANDUCER WE USE TO TAKE
OP IN 4-20MA , for RTD also .
| Is This Answer Correct ? | 4 Yes | 9 No |
Post New Answer View All Answers
what is the best method of grounding in 30 MW generator?
Brief working principle of stabilizer,application & safety precautions
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com
Which test will be more severe for VCB?
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
List examples of voltage source?
i want to know that how the height of Ct ,cvt ,LA calculated on the basis of creepage distance
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
Why Ac Systems Are Preferred Over Dc Systems?
