what is the difference between the 94 lockout relay and 86
lock out relay. I have noticed that the 94 lockout relay is
activated when the distance realy is activated and 86 is
activated when the 87T differential is activated. but why
can't the same lockouts be used for both the protection
schemes
- 10 Answers
- 65951 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / gtmanikandan
86 lock out relay is hand reset used for mechanical
protection (permanent fault) & 94 lockout relay is self
reset used for tranisent fault (temprovery fault condition)
this is major different between 86 and 96 lockout relay
| Is This Answer Correct ? | 39 Yes | 21 No |
Post New Answer View All Answers
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
I have finish diploma electronics and five years experience in electrical field in ht service how can i get c licensce or other electrical certificate
how to calculate the size of the HT cable
Why 11kv to be generated in generation station
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
Show the schematic arrangement of diesel power station layout and give its principle of operation.
How to maintain ac plant?
Refernce currents are to be generated using refernce cueernts how can this be done
How To Convert Apparent Into Real Power Without Knowing Reactive Power?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
What is the operating principle of turbo-generator.
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
