Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference betn earthed and unearthed cables
which is commanly used why?
- 2 Answers
- 7720 Views
- Bhel, Power Grid, I also Faced
- E-Mail Answers
Answer Posted / jasjit singh
If the electrical system is very efficiently earthed and all
protection are in place then we go for earthed cables and if
you have any doubt about the system earthing and its
protection then we go for unearthed cables. Basically its
the system earthing with which we choose earthed or
unearthed cables. I cannot say which is commonly used
because as I have mentioned earlier it will depend upon your
system earthing. But in few cases even if all protection are
in place and system is properly earthed we still go for
unearthed cables just to have extra safety margins.
Regards,
| Is This Answer Correct ? | 1 Yes | 22 No |
Post New Answer View All Answers
what curve and rateing would you use for a three phase 0.75kw motor?
Write the force balance equation of m ideal mass element.
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
how indusrial diesel generator work
How can you sized or estimate the ligthning arrester current rating?
When is lag lead compensator is required?
What type of DC motor would you see for a lift?
Explain dc generator with its types?
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
Draw the equivalent circuit of crystal oscillator?
I COMPLITED MY B.TECH AND 10TH CLASS WITH 70%MARKS BUT 12TH CLASS 55%MARKS..CAN I GET INDIAN RAILWAY RECUREMENT EXAMINATION?
How many types are using in 220kv/400 kv swith yard
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
When we need up only in o/p 440v, so why we use directly in 11kva in input?
