Why a starter is used for a motor?
- 50 Answers
- 134002 Views
- L&T, Nilachal Polytechnic, I also Faced
- E-Mail Answers
Answer Posted / salim
The starting current of motor is very high, as per its
rated full load current. It also has the low resistance. if
we start the motor without starter,since the resistance is
low, heavy current will flow through the windings of the
motor and will burn the windings. that is y we use starter
to increase the resisitance or u can say to reduce the
voltage .
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is the main difference between power devices and signal devices
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
Explain about Leakage Test.
what is a power factor?
State magnitude criterion.
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
If ROC does not lies inside unit circle,then ? a) Fourier transform converges b) Z transform converges c) Hatly transform converges d) Colpit Transform converges.
what will be the effect if you were using different brands of outlets?
What are the advantages of vscf wind electrical system?
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
what are inherent currents?
Define coil span?
in dc shunt motor if field winding is shorted then
