Answer Posted / laxman rabari
YES
| Is This Answer Correct ? | 7 Yes | 7 No |
Post New Answer View All Answers
Why we use mho Relay in long transmission line?
how to decide no of electrodes for 1600A LT Main incomer panel
show the single line diagram of star delta starter with single phase preventer
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
In Plumbing services What are accessories we consider for a bathroom?
what is lumped and distributed elements?
What is electrical diversity factor in electrical installations?
how we can calcultae the short circuit level for bus bar
what happen as when voltage drop(or may decrease) ? in case of atomic base theory?
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
what is consequences of neutral and earth connect?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
how to calculate the no load current in transformer?
How would your past experience translate into success in this job?
List the time domain specifications.
