what is meant by line voltage and phase voltage in a three
phase transformer?
Answer Posted / jayveer
Line voltage meancs voltage betweer two line and, Phase
voltage meancs voltage betweet one line with neutral.
(graund)
Is This Answer Correct ? | 21 Yes | 0 No |
Post New Answer View All Answers
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
what is the minimum voltage require to injure our body?
Explain cmrr?
What is the limitation of kirchoffs law?
why not starting switch first connect in direct on line starter?????
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
What kinds of decision are made about CT from it's Knee point(voltage & current)?
What is Anemometer used to measure?
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
sir, i am 3 years diploma course pass out candidate.what type of certificate can i got in marine service.
what is arc flash and what are the hazards involved
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.