What are the Timer of RIP, IGRP, EIGRP and OSPF Routing
Protocol?
- 20 Answers
- 79224 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / rutuja
The correct RIP timers as per cisco doc
Hellow interval 30 second
dead interval 180
hold down timers 180 second
n flush timers 240 seconds
the eigrp timers
hellow send every 5 second dead 15 second in point to point
in nbma is 60 hellow interval and dead is 180
in ospf
ppp hellow 10 dead 40
brodcast same
but in point to multipoing hellow is 30 secon n dead is 120
second
point multipoint brodcast same
point to multipoint non brodcast
| Is This Answer Correct ? | 29 Yes | 7 No |
Post New Answer View All Answers
In configuring a router, what command must be used if you want to delete the configuration data that is stored in the NVRAM?
Utilizing RIP, what is the limit when it comes to the number of hops?
Define bandwidth?
Explain how many types of router?
What is BootP?
What is the difference between the switch, hub, and router?
What are the disadvantages of symmetric algorithms?
What is the difference between an igp and an egp?
Can you explain encapsulating, carrier and passenger protocol?
What is a network subnet?
What is the difference between ‘bit rate’ and ‘baud rate’?
How does rip differs from igrp?
what command you must use if you want to delete or remove the configuration data that is stored in the NVRAM?
Mention the conversion steps of data encapsulation?
How many reserve ports?
