why transmission line 11Kv OR 33KV,66Kv not in 10kv 20kv?
- 43 Answers
- 113965 Views
- A2Z Group, Baiji Power Plant Gas, Electrical, HCL, Kirloskar, Mepco, NEPC, OAMC, UNI, University of Lahore, I also Faced
- E-Mail Answers
Answer Posted / nikesh gupta
It is because of the power factor reasons as we have
nornally approximate .90-.91 power factor for transmission
line ..if we calculate for POWER VIcos@ then we will have
exactly a intergral no.
For ex 11000*I*.91=10I Kw
33000*I*.91=30I KW
| Is This Answer Correct ? | 3 Yes | 12 No |
Post New Answer View All Answers
What is the normal phase difference between the voltage and the no-load current in a transformer?
what the principle of sincroscope?how it works?when it needed?
Battery is a voltage source? give one example of current source and why?
why current flow to the opposite direction of flow of electrons???????????
Air refrigeration cycle works on the
what curve and rateing would you use for a three phase 0.75kw motor?
What are electric motors?
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
why not starting switch first connect in direct on line starter?????
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
Define piezo-electric effect?
Classify drilling machines.
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
What is the formula to calculate a three phase alternator
