IN HT MOTOR HT REFERS TO HIGH TENSION OR HIGH TRANSMISSION?
- 11 Answers
- 13457 Views
- I also Faced
- E-Mail Answers
Answer Posted / venkat
HT means high tension
| Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
what are types of encoder
Explain about technical and non technical losses in distribution system?
WHY BREAKER ARE USED IN SUBSTATIONS?
Where burned of electricity,when,who, & why.
iam working in power plant. In hot places tube lights are glowing at the end portion only. what is the reason for that?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
What is the effect of positive feedback on stability of the system?
I WANT HOW CALCULATE TO CABLE FOR WELDING PLANT ?
What is the count of hvdc transmission lines in india?
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
Difference between rating factor of cable and derating factor of cable?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
