what are different types of excitation in synchronous
generator,what is the difference between them
- 3 Answers
- 15714 Views
- I also Faced
- E-Mail Answers
Answer Posted / sohail
Normally D.C excitation is used for exciting the field wdg
of generator. A.C excitation is also used but through
rectifier and supplied through brushes and sliprings.
Nowadays brushless exciter with field ckt on stator and
armature on rotor with rectifiers are used, directly
connected to the field wdg ,eliminating the use of brushes.
| Is This Answer Correct ? | 27 Yes | 5 No |
Post New Answer View All Answers
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
differnce between single acting and double acting solenoid valves
which type of stability limit is higher,steady state or transient? why?
Which type of questions well asked. ?
Draw a block diagramof Three UPS systems connected in Parallel mode?
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
please send 5yearje solved papers on my email himmatsinghnathawat@gmail.com
How to calculate that clean water supply in one Day from 150 KLD STP?
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
WHY THE DIMENSION OF TWO SAME RATED MACHINE IS DIFFERENT ?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Which motor is 3.3 or 11kV more reliable, in terms of efficeancy,maintenance, reliability.
