What is loop or pigtail in an impulse line?
- 8 Answers
- 32355 Views
- Qatar Airlines, Qatar Petroleums, I also Faced
- E-Mail Answers
Answer Posted / solomon
pigtail is also called syphon.It is used to reduce
temperature of fluid like steam before enter in to the
Pressure gauge or Presssure Transmitter for measurement
| Is This Answer Correct ? | 26 Yes | 3 No |
Post New Answer View All Answers
How to work togather like sov,limit switch,proxy switch and booster in xv
how to convert cubic metre per hour to newton cubic metre per hour
what is the calibration procedure for transweigh make weigh feeder?
Draw a great bridge circuit.
Why not come out analog output in ABB EL3020 when display show correct value
why orfice is not used for main steam flow calculation
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
can we create an interrupt in plc through scada?
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Explain the use of hair spring in the pressure gauge.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
how many types of spped sensors n vibration sensors?their basic principle n connection?
