why does cycle rim dont bend even in heavy loads???????
- 7 Answers
- 11084 Views
- Nissan, I also Faced
- E-Mail Answers
Answer Posted / parag
The spokes distribute the load throughout the rim.
Here's how :
Make a small ring of a thin steel wire. Hold it between your
finger and thumb, and press. It will bend.
Now, tie a straight piece of steel wire diagonally, and
press the ring at the ends of the straight wire. You will
need much more force.
But, the same ring will bend with lower force, if you press
it at points where straight wire is not there.
Now, tie many such straight wires on the ring, and then
press the ring.
'hope you got the picture clear :)
| Is This Answer Correct ? | 51 Yes | 3 No |
Post New Answer View All Answers
"What is the remedy if due exchanging, valve broke out during engine running operation?"
What is meant by laminar flow ?
What materials use to make valve body, and What data needs to choose correct valve size
why we r recommended for pre-action sprinklers @ generator/tx/mv panel room. If any leakage there,that panel will damage. So what is the Logic for pre-action sprinklers there?
What is max pressure?
As a foreign applicant, what do you understand about our company before sending your application CV for consideration?
What are the causes of damage of diesel engine exhaust Valve?
give the sample format of boq plumbing materials
What is the specific gravity or relative density of fuel oil?
Draw L.O. system in diesel engine?
safety of centeral chiller plant
Can contractor purchase as cst purcbase who is registerd under wct act in mp
what is the meaning of MIN MAX?
Which theories of failure are used for ductile materials ?
what is punching force required for embossing of depth 3.5mm and diameter 58mm
