Can anybody tell me how to calculate(formula) earth flat
size(for copper and aluminium).
- 3 Answers
- 5864 Views
- I also Faced
- E-Mail Answers
Answer Posted / manjunatha.h.d
mr.sarvan any specific formula is for that
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is Fault level? why it is calculated? how will u decide same for our plant?
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
What is inductance?
why lightning arrestor are made in two stack of insulator but why not cvt
how to calculate IR value of 33KV cable ??
why do we have spikes enough to burn electronic boards, when generators are not grounded
why do we put a transformer on soak before loading it
if we have 320KVA Genset kindly advice how much load we can put it.
What do you mean by pull of electromagnet?
what is the condition for YnD11
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
Why synchronous motor is used in power factor improvement,dc series in lift
