Answer Posted / k.jeganathan
1.Cement content
2.W/C Ratio
3.Size of aggregates
4.Shape of aggregates
5.Type of Admixture used
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
What is command line?
What should be the lap length in raft if height of raft is 0.800mm ...it couldn't b 50D or 40D...we just have to join upper and bottom reinforced...is there any formula for determine it...
How do you calculate reinforcement weight of steel?
What is the use of array command?
You have 3 snd sample of different FM=0.21,FM=0.95,FM=2.90 which one is suitable for a)plastering on R.C.C b)plastering on masonary wall c)concreting column d)concreting of bored pile.also justify your answer.
Dear Engineers, Can you please advise me the material requirement to construct a room 4 M x 4 M 1. No. of Standard Brick 2. Requirement of Cement Bags 3. And Concrete for Steel, Cement, sand, etc Thanks
What is the basic difference between OPC
what is the most suitable foundation when construct a bird watching tower in a marshy land
If we don't have drawing for Excavation of building,At what rule we will go for excavation and how much depth will go for a villa?
What is zoning permit?
what is difference between GTS bench mark and temporary bench mark
Define What is the origin of name Railway Sleepers?
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
Tell me about triple point of water.
how to calculate quantity of cement,sand & aggregate for u.c.r / r.r masonry in cm 1:6
