Answer Posted / gaurav srivastava
synchronous motor have 3 phase winding which is having
altarnating rotating nature and the rotor of motor have dc
wwindig which is connected to a dc source due to this the
rotar become magnetished thus there are two poles form in
rotar. that is South and North pole...since the stator
winding are 3phase so that the stator become magnetised but
it is change alternatively.....but there is main reason
that to zero starting is the alternating magnetisation is
very fast (in approx 1/20 sec)so that there is no pole
coupling in rotating stator field and rotor..so that is is
not self starting...
for this there is a prime mover is used to rotate it ..
by this there is magnet copling is formed so that it can
run...
there is main function of synchronous motor it always run
on synchronous speed..
MUST REED THIS/////
=>if motor start to run and there is a phase cut (one of
three)....it is not affect on the motor speed
GAURAV SRIVASTAVA (UNITED COLLEGE OF ENGINEERING AND
RESEARCH)ALLAHBAD
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
why transmission is only 3 phase and not 2 or 4 or poly phases
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
What is the difference between circuit breaker and isolator
why dc is used in control circuit for mv & hv switchgear instead of ac
what is the write prosidure of stringing of 8meter pcc pole.
which type of effect of turbine and generator reverse power protection ?
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
How to calculate VCB rating for 33KV ,25 MW Power line?
what id a dry type transformers and its function ?
What are the main significances of root locus?
Alternator rotor earth fault relay circuit
what is Anti-pumping?
iam working in power plant. In hot places tube lights are glowing at the end portion only. what is the reason for that?
