IN PLATE EARTHING , PLATE LAID IN VERTICAL POSITION ,WHY
HORIZONTAL WHY NOT
Answer Posted / jamal_bsp
Plate earthing is better laid in vertical position since
it will require less excavation .However horozental
position will also suffice the purpose.
Is This Answer Correct ? | 0 Yes | 13 No |
Post New Answer View All Answers
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
ITI r/tv trade APPLY (J.T.O VACANCEY) ALSO INCLUD AITT ELECTRONIC,WRITEEN XAM DONE 23.03.10 BUT NO RESPONCE WHY ANATHER ID gopal_gh007@rediffmail.com
What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?
sir vizag steel ka junior trainee ka paper kitne number ka ayega
why asa method ZPF method is more accurate than ASA method?
How to calculat the ratio of HT\LT in energy meter
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
What is precision of a measurement?
How to calculate multiplying factor of dc energy meter
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
Why Neutral Isolation is required?