HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN
ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii)
DELTA LOAD, USING A CLAMP METER.
NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO
WE GET?? PHASE CURRENT OR LINE CURRENT.
Answer Posted / nirav_patel2120
The current flowing in each line is called line current.&
Current in each winding is likewise known as phase current.
In star load
line current=Phase Current.
In Delta load
line current=√3 Phase current.
Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
what is meant by impulse voltage?
How can we calculate the transformer rating if the load calculated is 1000KW (11Kv Supply)?
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
diff. between tension mode & speed mode
Is neutral transformer can be called as control transformer?
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
What are books to be referred for KPTCL exam?
What is the method of estamating of cable, CB,MCB ?
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
What is the importance of earthing?
design a 3 bit synchronous and asynchronous counter using T- flipflop
list of tests to be carried out at manufacturers end while purchasing a step up transformer of 11kv to 66kv ,2MVa Capacity.
How to size fuse? How to size MCB?
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?