why electric shock due to dc is dangerous than that of ac
- 44 Answers
- 58441 Views
- I also Faced
- E-Mail Answers
Answer Posted / piyush rana
In Ac, due to sine wave, the voltage wave is coming to zero
at some instant during this time there is chance to get
released from the sock, but in DC the waveform is straight
& not coming to zero at any instant, So there is no any
chance to get released from the sock.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
What is earth?
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
How to calculate the time setting for star connection in star delta starter? For example 10KW 3PH Induction motor.
What happens if we connect a single phase energy meter in reverse polarity.
DRAW ACIRCUIT DIAGRAM OF 100 KVA 415V/55-0-55V DELTA TO STAR TRANSFORMER
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
which pump used in STP
why we need to us lenz's law for synchornous motor
ult of expression 'document.FrmQF.myem
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
WHAT IS MEANT BY DERATING OF THYRISTOR?
A low wet bulb temperature indicates
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
