What is meant by H.R.C fuse?
Answer Posted / c.mahadevan
high rupturing capacity fuse(it is time delay
characteristics and arc arresting and blost)
Is This Answer Correct ? | 37 Yes | 31 No |
Post New Answer View All Answers
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??
What is the effect of interchanging core(made of steel) and winding(made of copper) material in case of transformer? Give proper explanation in regard to different losses in transformer.
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
How will change the frequency in distribution side?
what is the standard duration after failure EB power
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
What are the advantages and disadvantages of open loop control system?
How to perform a DC resistance test In Alternator and their proceduces?
what is meant by motor startup supervision & motor load jam protection ?
What are the transformer losses?
how to calculate units consumption for a 12 hp motor /hr.
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1
Which do you think is the most significant cause of energy loss in a factory?