Answer Posted / deepesh
1) As stated earlier, 4mA is used to avoid the conflict
between live zero and dead zero.
2)In 4 mA to 20 mA range, current to pressure converter
gives linear output.
3)This range is intrinsically safe.
4)Low power consumptions
| Is This Answer Correct ? | 17 Yes | 2 No |
Post New Answer View All Answers
Specify for Cables - Flame Retardant and Fire Resistant?
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
Make Heater Process Logic.
what is gas metering system? gas chromatograph? and gas compressors?
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
what is the imbustion control loop
How we calculate orifice plat size???
What is the difference between uv and ir scanners? and what is the workig principle of both
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
for oil & gas industries which zone is normally preferred? why? give its example?
how to calibrate corollaries (Mass flow meter)?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
