What is power factor? Whether it should be high or low ?
why?
- 9 Answers
- 30829 Views
- I also Faced
- E-Mail Answers
Answer Posted / gunjan
power=VI cosX
=> I= power/(V CosX)
for low values of P.F. the current increases leading to
more copper losses (I*I*R) and hence heating. more losses
lead to low effeciency of the system as whole which is not
desirable.
| Is This Answer Correct ? | 14 Yes | 4 No |
Post New Answer View All Answers
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
What information we need to prepare relay coordination chart
how solar power plant energy meter multiplication factor
how does ELR works? explain
What are the various types of BUSBAR Schemes? explain each
What is the difference between alternator and generator?
What are the three types of compensators?
What is the phase relationship between the primary and secondary voltages of a transformer?
How would you relate your key competencies to this position?
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
Why r u using pf panel. what the uses
Can anyone tell the proper diagram of star delta starter????
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
