After the command -- router igrp 200 -- what command would
enable
IGRP on the router for interface E0, with an address of
157.89.4.4 and a
mask of 255.255.255.0 ?
A.) network 157.89.4.0 255.255.255.1
B.) network 157.89.0.0
C.) router igrp *
D.) router igrp 157.89.0.1
E.) router igrp int e1
F.) router igrp 157.89.4.1
- 2 Answers
- 4725 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijay chandar
answere is (b) because we have tell the router which
network should be advertise routes for and this is done
using command network network_address
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What are the disadvantages of symmetric algorithms?
What is a Window in networking terms?
What are the different types of passwords that you can use in cisco routers?
What is subnetting and why it is use?
Explain how many types of router?
If line up, but protocol down which layer should be troubleshot?
Is hub intelligent device?
How we can see mac address from dos prompt?
What is difference between routing and routed protocols?
In how many ways you can access the router?
Tell us the name of best path in eigrp protocol?
What is GRE in PPTP?
Define class full protocol?
What are partial updates?
What is the maximum value of administrative you can use?
