HOW TO CHECK THERMOCOUPLE AND RTD & WHAT IS THE DIFFERENCE
BETWEEN THERMOCOUPLE AND RTD
- 14 Answers
- 95132 Views
- I also Faced
- E-Mail Answers
Answer Posted / sushma
RTD will be find by R2=R1(1+alpha(t2-t1)) Thermo is used to
measure both AC&DC. In Teromcouple characteristics between
Rstistance & tepmerature is non-linear where as in RTD it
is linear.
| Is This Answer Correct ? | 25 Yes | 46 No |
Post New Answer View All Answers
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
why we are using magnet for calibration of gas detector?
Decibel.
how to check earthing,what is minum ohms for proper earthing
What are different types of cable?
please send me some question papers of HPCL aptitude test ?? please send it to bipinb.28@gmail.com ...
How to calibrate smoke Dectector
What are different types of orifice plates? State their uses.
please send data bank of quetions answers on analytical instrumentation.
Calibration procedure for electro magnetic flow meter
what is wave length were using ?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
full process of gas turbin?
