what is the technical diffrences of mccb and acb
Answer Posted / sunthosh080
All the above answers are correct and little more to add
from my side.
usually these breakers are used for short circuit
protection to a valid value.
The max. KA in MCCB is 50 KA and in ACB it is 100KA. So the
selection also depends on the short circuit level to be
protected.
Now a days all the breakers are microprocessor based
protections with all parameters.
Is This Answer Correct ? | 20 Yes | 7 No |
Post New Answer View All Answers
In case of generator when we consume more power produces by it why load on generator increase and starts sound more. and how it is adjusted..
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
how to test reverse power trip?
can i use the six sigma method which is used in management area, in state estimation of power systems?
how we can calculate the efficiency of a diesel generator ?
how could we calculate the no of outgoings from a 800 watt distribution board
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
HOW WE CAN REDUCE THE CIRCUIT COMPLEX OF STAR-DELTA STARTER .BECAUSE NOW WE USING ONE TIMER RELAY & THREE CONTACTOR FOR MAIN,STAR & DELTA ?IF ANY IDEAS PLZ POST.THANK U
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
how the characterstics of control valve being done
What is Antipumping Function & If we have C.T how we find the Ratio ?
what is buffer resistance starter.?.What is the working principle and where it is used..?
why ct ,cvt should be stored in a vertical position?