HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN
ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii)
DELTA LOAD, USING A CLAMP METER.
NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO
WE GET?? PHASE CURRENT OR LINE CURRENT.
- 13 Answers
- 32204 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / sudheer
line current means the current flowing through the AC
supply lines.phase current means current flowing through
each phases like R or Y or B phases.relation between line &
phae currents are
star connected system: phase current =linecurrent
delta connected system: phase current ={ linecurrent/√3}
for balanced 3Ф 4W system current flowing through the
neutral will be sum of phase currentsand will equal to zero.
ie Ir+Iy+Ib =0 =In
| Is This Answer Correct ? | 25 Yes | 15 No |
Post New Answer View All Answers
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
I completed iti in2004 I was worked in A grade contractor can I get c licence
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
how to select automotive wire by mathematical equation with given current, vlotage and resistance
what is lrs tank water resistance.
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
Name the component u would expect to find in a switchgear assembly?
Power Factor Correction Panel (Manual & Automatic)
redundant connection in contactor?
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
