Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / prabhat kartikey , me, iem, sg
Define, Measure ,analysis , The next step is Improving And
after contol.
Improving means some coorective action For Geting Desired
Result, or increase the productivity, Quality, Etc.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is process planning?
I want to know about a good liquid scrubber that we can use in acid washing.
What is producer for anti-collision protection for dumer 220ton in minse?
Explain overhauling stopsfor backpull our pumps?
Explain why are the major iron and steel industries in india located in eastern india?
why we give dedusting steam in feed gas coils in convection section of primary reformer?
pls sir can any body tell me the important questions of power plat operatoe my id is ali.ind85@yahoo.com plss
How do you estimate the fuel /diesel consumption for 125KVA DG Set?
What are the uses of time standards?
dear friends, pls tell me why silicone oil is used as dielectic medium in pressure transmitters
how do you check pump impeller back clearance?
What you know about ISO 9001? What is quality management system? Weather QMS is suitable,adequate and effective or not? Is there any Quality Policy? Is there any Quality Objectieve? If yes, then what are they. How they are planning to achieve Quality objectives? Weather they are measuring quality objectives?
Let’s say we live in a country that gets very cold, in Northern America / Europe. In winter, we monitor the ouside temperature, so that heaters can be switched on, inside the house. The idea is that, the colder it is outside, the warmer it should be inside. The heating side of things is just a heater that is either switched on, or switched off. Just from the information that has been given, please discuss this matter in depth. Provide reference to OPEN / CLOSED loop control, FEEDFORWARD / FEEDBACK control and MODULATING / ON_OFF control raised in the discussion.
what is machine tpm
What happen if we install flow meter with orifice plate, but bevel position is in upstream and not in downstream
