Interested to Buy Any Domain ? << Click Here >> for more details...
How one can check the faulty capacitor, diode when
connected in the circuit ? and when you can not take them
out ?
- 4 Answers
- 10496 Views
- I also Faced
- E-Mail Answers
Answer Posted / eduard
its simple to check them electronics component... first,we
have called capacitance meter for "Capasitor,you can check
for leak and faulty, capacitance means uf (micro farad.two
types of faulty "Capasitor, Leak and called white subtance
oszing. "Daiode you can check faulty the two terminal when
its test to polarity forward/reverse has continuity mean
Shortage. 500ohms good below 500ohms means leak.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
give me atleast four differences between circuit and network
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
If anyone would like to know or practice for FEWA papers contact me on mohamedrashad2@hotmail.com Just completed the supervisor exam in April 2021
i want to model paper for section engg.
How to calculate the heat load for a electrical room
role of europe union in UK safety legistlation (electrical safety)
What is state space method ? Why its used ? Can it applicable on linear, non-linear, 1st order, higher order, homogeneous, non-homogeneous, open-loop , closed loops , stable & unstable systems ?
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
Why air circuit breaker off due to power failure?
