Answer Posted / asif javaid
FIRST SEE ITS PRESSURE RANGE APPLY INPUT PRESSUR 5PSI
MORE THEN MAXIMUM RANGE OF OUTPUT PRESSURE AND SEE ITS OUT
PUT THEN APPLY 4MA AND SEE OUTPUT SIGNAL 3 PSI NOW ADJUST
3 PSI FROM ZERO ADJUSTMENT SCREW NOW 8 12 16 &
20MAAPLY AND CHECK MAX PRESSURE RANGE NOW ADJUST FROM SPAN
SCREW
( RANGE CAN BE DIFFERENT FROM 3 TO 15 PSI )
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
How many types of sensor
How d.p. Transmitter can be applied to open tank?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
Explain why plc require in analog input 4-20amp & 0-10 volt?
what is effect of specific gravity in differential level transmitter , explain formula related with this .
What is the diffrence between ff tx and non ff tx
how can use ram
Explain the working of rota meter.
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
Difference between dcs and plc including date processing and architecture.
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
what is the usage of QDV & VOLUME BOOSTER
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
