what is the use of starter in tube light?and what it
contains
- 12 Answers
- 46326 Views
- L&T, RRB, I also Faced
- E-Mail Answers
Answer Posted / sam khanji
The main reason for the starter is to provide the spark
inside the tube which ionizes the Nion gas inside the tube.
The Nion's electrones at the last orbit will jumb to the
next orbit providing light.
the starter contains a capacitor with a very low
capacitance and has the ability to discharge quickly.
| Is This Answer Correct ? | 54 Yes | 19 No |
Post New Answer View All Answers
what is the use of piston rings in the engine used for a generator...........
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
is it possible to have dc motors on single chip
How to calculate ant test the burden of Current transformer
How to checked frequency drive output voltages?
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
can the measured percentage error during calibration of single phase energy meter be negative?
what is Fault level? why it is calculated? how will u decide same for our plant?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
how could we know the size of cable by physical view?
will there be any problem by recovering slip from single phase induction motors?
what is vtg limit of earth and neutral at transformer side?
What is power in wattage of 8.5 TR AC
