Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the size of the conductor for particular
load
- 9 Answers
- 28865 Views
- Eskom, HCL, I also Faced
- E-Mail Answers
Answer Posted / sam khanji
the size of conductor is depending at the following
1- load
2- distance
3- type of conducter
4- if the conductor is outdoor or indoor
usually the size of conductors could be calculated based on
voltage drop and based on the mentioned above
| Is This Answer Correct ? | 35 Yes | 5 No |
Post New Answer View All Answers
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
what is the difference b/w absolute encoder and incremental encoder?
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
What is primary and backup protection?
How one can check the MAIN of a house wiring ?
What is stepper motor. What is its uses?
What OPGW is better than Microwave or PLCC???
How to measure the earth resistance value in a concrete pavement(flood light area)?
advantages and disadvantages of inverse definite minimum time RELAY
send me any model test paper of clerical post of state bank of india.......
What are the advantages and disadvantages of open loop control system?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
