xplain in detail d pr. of synchronous motors? why syn.
generators r used for the production of electricity?
- 4 Answers
- 6550 Views
- I also Faced
- E-Mail Answers
Answer Posted / ranjeet rohilla
synchronous machines have capability to work on different
power factor(or say different imaginary power levels) by
varying the field emf.
However not only synchronous generators are used for
production of electricity. In case of wind power, induction
generator are used and for controlling the imaginary power
capacitor banks are used.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
What is Bolted fault?
How to test Alternator stability test for REF relay
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?
How to size fuse? How to size MCB?
What is the relation between frequency and motor rpm?
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
Why in power plant projects we see DOL starting method used for motors upto 160 kW instead of star delta method
