In what circumstanced the CT used for protection relay will
be saturated?and what will happen to the relay is the CT is
saturated?
Answer Posted / tameshwar singh
The CT saturation occurs when secondary winding is kept
open. At this time there is no demegnatising current flows
in secondary winding and due to this primary winding will
carry very high megnatising current.As the high megnatising
current produces high megnatic flux which causes the CT
core saturation
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
how point on wave controller works.
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
What are the types of excitation system?
What is EHT tariff or Power factor Tariff ????
What is the meaning of C1, C61, C91 cable
Define piezo-electric effect?
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
How to decide cable tray size?
For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
If a high resistance fault occurs,then what are the changes will happen in the system?
what is the effect of power factor of machines in starting current
Inverter. converter. Ups.MCB.solar.alternators. motors.
what is JE exam?
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.