Answer Posted / s.saravanan
Na
Is This Answer Correct ? | 14 Yes | 2 No |
Post New Answer View All Answers
What is the best way to handle bend or turns in slurry piping systems?
Explain the difference between cfm (cubic feet per minute) and scfm (standard cubic feet per minute)?
Is there a rule of thumb to estimate the footprint of a cooling tower during design phase?
what is the purpose of capacitor? and capacitor load means what? how does it connect?
which accomplishments in your present position are you proud of and why?
When should one be concerned with the tube wall temperature on the cooling waterside of a shell and tube exchanger?
What is a good source of equations for calculating discharge flowrates from accidental releases?
The job profile as a Service Engineer?
When specifying a cooling tower, should I look up historic wet bulb temperatures for my area or should I take measurements?
Explain why is post-weld heat treatment (stress relieving) sometimes necessary for welded vessels?
What is the ignition temp. of Aluminum,Coper&Iron.
What type of pump may be appropriate for a liquid near saturation, a low flow rate, and very limited npsha (net positive suction head available)?
y we do not differ b/w atomic mass and atomic wieght? from engrtauseef2008@gmail.com
How 'saltation velocity' is used in designing pneumatic conveying systems?
How many years you are having experience in supervising others in lab environment?