what does d-flip flop stand for?means what is d there?
- 13 Answers
- 16498 Views
- I also Faced
- E-Mail Answers
Answer Posted / thiru
d means delay. gegerating a delay output for the
corresponding input.
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
what is the use for electrical c licence
Tell me how to calculate knee point voltage? Describe its purpose for differential protection.
is below 2 ohms earth resistance is good for mobile tower
why qpsk is done for 45 135225315 not 0 90.270 360 degrees "degrees why "
What are the applications of comparator?
I am stuck up with a question on appending of two arrays
I am writing the code for the same, I am appending two
strings this way
int main()
{
string s1 = "Welcome to C++";
string s2 = "C++ improves the logic ability";
string s3 = s1 + s2;
cout< "11101111" when that bit oriented message transmitting from
sender to receiver.how is it calculate parity bit and how is
it show bit stream that would be transmitted..by even parity
error detection scheme..pls send me an answer..very important,, what is the difference between delegation and containership? Which is the fastest logic ? send me cutoff of surat nit for m.tech what is the wireless access subscriber unit(WASU) and how
does it work? What is the protocol in PLC What is an ac emitter resistance? What is meant by unidirectional or half-wave ac voltage controller? What is DTX? Why is it used?
