I have 800 Amps MG Fix type breaker It is in on line & it
has been given only UV (under voltage)coil connection for
tripping purpose.now it is not working properly means its
getting tripp so how can i replace it or how can i rectify
the problem without destrubing my load??????????
- 2 Answers
- 3770 Views
- I also Faced
- E-Mail Answers
Answer Posted / sandeep khaire
Short the UV relay contacts used in wiring. Then replace
the UV relay & its contacts.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
why dimmerstate always connected in star connection? what will happen if it connected in delta?
How to decide and select the different earthing wire size for the different types of earthing
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
How do I calculate a WTI CT ofa 1250kVA 6600/400V transformer
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
compare between starting charactristics of synchronous motor with those of 3Q Squirrel cage induction motor
What is an alternator impedance value?
can anyone explain 11kV 3core cable megger,hi pot test procedure with connection details?
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
What is the role of Dedicated earthing in UPS System?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
when elecromagnatic waves are propogated in a wave guide?
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
