Interested to Buy Any Domain ? << Click Here >> for more details...
What is the function of trip neutral close switch?
- 11 Answers
- 70323 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanket patil
A TNC SWITCH IS ALSO CALLED BREAKER CONTROL SWITCH. IT IS
LOCKABLE IN THE NEUTRAL POSITION AND IS A THREE POLE SWITCH.
WHEN IT IS IN CLOSE POSITION THE COMMAND IS GIVEN TO THE
CLOSING COIL OF THE CKT BREAKER AND THE BREAKER CLOSES.
WHEN IT IS IN THE TRIP POS COMMAND IS GIVEN TO THE TRIP
COIL OF THE CKT BREAKER AND THE BREAKER TRIPS.
| Is This Answer Correct ? | 9 Yes | 7 No |
Post New Answer View All Answers
How to decide DO set rating of Transformer?
Why AC & DC capacitor are use in UPS ??????????????????
what is mind in cable
What is the difference between a Root Locus plot and a Bode plot?
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
what is dc mator?types of dc motor?losses in dc motor?what is the mechanical,electrical and commercial efficiency of a dc motor?
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
if a number of plc s are there then how many modbus to be used
How can i get my certificate of competency as an electrical supervisor? I have complicated my B.Tech from Uttarakhand technical university this year (2012).
Difference between drift current and diffusion current?
What is control system?
what is the function of impulse relay
In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
