diesel generator worked as principle of faraday's law of
electromagnetic effect.mechanical energy is converted to
electrical energy.It can stared to d.c supply i.e. 12v ,
24v.D.C supply to starter and after starting it produce
A.C. supply.Engine only use as a prime mover.
Please Help Members By Posting Answers For Below Questions
What is the types of HT motor testing
How to work E.L.C.B and how to connect in circuit.
what is Different between Bilinear and Unilenier?
what can be the causes of capacitor start motor having a
higher current that its actual
In radial network the source is fed from
1 end both ends at central
advantages & disadvantages of Lagging and leading power
Why should we hire you over the others waiting to be interview?
when it is possible kvrah lead & fundamental kwh be equal
in electonic trivector meters (3 ph)
Isi standard of lux level required / to be maitained in
different working place general & in textaile industry.
Is there a possibility to use such a treshold voltage for
the NMOS part of a CMOS circuit that during the switching
it will start conducting only after the PMOS part will be
already closed, by this eliminating the leakedge current?
Please note, I'm not asking about the well bias in standby
mode, but about the "antileakedge" measures during normal
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF
THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO
POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF
CURRENT I SHOULD USE WHICH TYPE OF CABLE?
How the frame size of a flange mounted AC induction motor is
how to find out basic difference between ELCB,MCB AND RCCB on seeing the materials?
1. Is it required to lay two runs of GI wire along
with Armoured LT cable if it is laid between one big mains
(63Amps TPN SDF) to small main (32A TPN SDF) with proper
2. If the armoured cable with proper glanding is laid from
DB to CNC machine, is it required to run two runs of body
earthing to the Machine from DB?
3.If the armoured cable with proper glanding is laid
from Substation to Hangar, distance is approx. 100 mtrs, is
it required to do earthing at shop area though the primary
termination at substation is earthed through gland.