Where there is voltage,there must be current.Is this right
or wrong??
Answer Posted / padmanabh thakur(geu)
in case of open circuit,voltage is equal to emf of cell but current is equal to zero
Is This Answer Correct ? | 28 Yes | 0 No |
Post New Answer View All Answers
draw the block diagram of fire alarm?
how to select correct size of power cable for inverter duty motor
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
How to design harmonic filter at the project stage without nowing the harmonics levels
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
Why we use circular(Stepped) cross section in transformer core?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
how many safety really of DG sets.
how is the incoming cable size calculated for a given current rating of a panel??
what is the formula of starting current of 3phase and 1 phase motor???
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
if any house we instaled a 1.5 ton ac and its phase cable of wiring is installed but netrual cable of wiring not instaed. my question is that is neutual of house(for other wiring is capable for ac load or a sepeart neutrual wiring required
what is different between phase and netural
Grid fault level [KA]?