why twisted pair of wires is used in instrumentation ?
- 6 Answers
- 22107 Views
- ONGC, I also Faced
- E-Mail Answers
Answer Posted / banibrata mukherjee
Twisted pair of wires is used in order to avoid inductive
coupled interference signals.As a result of twisting the
loop area between the conductors is reduced & so induced
current in the wires is also reduced & external magnetic
field effect is also minimized.
| Is This Answer Correct ? | 23 Yes | 3 No |
Post New Answer View All Answers
in mass flow meter what is drive friquancy ?
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
What is cut off relay? And why use in PLC and DCS?
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
How addressable fire systems work? Pl. send details with architect.(Loop), also send details regarding Gas system. Pl. help me.Thanks
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
how to work static pressure sensore how to work dpt
