Answer Posted / pritesh
simple, the load which is joint with the transformer is not
known so that we dont know the actual power factor because
of reasion the rating of the transformer is in the kva not
in kw.
Is This Answer Correct ? | 12 Yes | 10 No |
Post New Answer View All Answers
what is static frequency converter?what is the function...of sfc...?
specific difference of ICT&Auto Transformer
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
how was your last weekend.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how is the incoming cable size calculated for a given current rating of a panel??
what purose of the double circuit transmission line phase of the line phase changed for circuit-1 for Circuit-2 R-Y-B B-Y-R
What is the basic of DTH.
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
Difference between ac parallel circuit and ac series circuit?
What is the effect of positive feedback on stability of the system?
What is Load sharing of Transformer ?
what is the total power generation in india?
describe the constructional features of an auto transformer and its principle operation
explain the types of drives