how to troubleshoot when protocols is down and link is not
getting up
- 7 Answers
- 9259 Views
- HCL, Sify, I also Faced
- E-Mail Answers
Answer Posted / naveen kumar sharma
just write a command "sh ip protocol" if link is down check
the ip address that u have put on serial interface or
ethernet interface or chk the clock rate at the end of dce
!!!!!thats it
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
Explain the term 'multicast'.
What cable called v.35?
Which command we give on privilege mode for coming back to user execution mode?
When we use standard access-list?
Tell me how much hold down time of eigrep protocol?
How many maximum paths you can give on latest ios in rip?
In port based access-list which command u give instead of ip?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
Which protocol called rapid protocol?
How much hold down time of eigrep protocol?
Why mac address called physical address?
What is the icmp protocol?
Define ios?
How does cut-through LAN switching work?
What is 10base2 ethernet lans?
