what is SHEAR WALL ? why and where it is provided.
Answer Posted / priya
shear wall is ,concrete wall made to resist lateral forces
acting on tall buildings.It is provided ,when the centre of
gravity of building area & loads acted on it differs by
more than 30%. in order to bring the c.g in range of 30%
concrete wall is provided i.e lateral forces may not
increase much.
Is This Answer Correct ? | 107 Yes | 13 No |
Post New Answer View All Answers
we have a crushing plant and our product is experiencing flakiness and elongation over limit for granite. what is the solution to this problem? how can it be avoided and what to do differently? It is not ok for batching plants
What is unit weight of roadway layer.. 1.bitumen 2.sand 3.soil 4.concrete 5. aggregate give me some reference for this answers
what mean By core Billing
The definition of national highway
What is GSB gradation
How to find permissible diagonal tensile stress in reinforced brick work
What was asked in isro civil interview
How much for the BRC lapping in full yield and half yield < and which table to get it ?
what is the dimensions of river sand truck trailer or trolly ?
what is box type waterproofing and how it is exsiccated and what is the method of doing box type waterproofing
What are the points to be considered for calculating cement reconciliation. a)Do we need to deduct the wt of cement bags b)Do we need to adjust the qty due to wt loss during transportation, loading unloading etc or else each bag can be considered as 50 kg bag c)What is the proportion of mix cover block making.
which red: used in roof teping, then use only cement
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
The internal dimensions of a wire house 15m*5.6m and the maximum height of piles is 2.70m. What is the maximum number of bags to be stored in two piles ?
Hi how r u ? hope you are fine there . Please can u tell me tha Design life of Buildings as Per ACI CODE 318-99. It will be a pleasure for me .Thanks in advance