what is plc?
Answer Posted / t.pitchaikannu
PLC(Programmable Logic Controller)
----------------------------------
* It is a controller which is used to control machines ,
process,or total industry
* It is programmable ,depending upon application we can
change the program ,download and run the controller.
* They are so many logics are used to write a programme
1.Ladder Logic(LD)
2.Instruction List(IL)
3.Function Block Diagram(FBD)
4.Structure Text(ST)
5.Sequential Flow Chart(SLF)
* From this name itself it used to control the
applications by programming the logic.
Is This Answer Correct ? | 32 Yes | 5 No |
Post New Answer View All Answers
What is the cascade control
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
Difference between ultra sonic flow meter
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
What are different types of valves?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
if in a level tx height is given, how u calculate the ranges of the tx?
What is intrinsic safety mean.
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
What is the start up procedure of desalter
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
what is easiest way to read STL language in PLC?