what are the basic concept to design a out door Substation?
- 1 Answers
- 6707 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohit
1)it should be locaed at load center so tht losses can be
minimized
2) to minimize the voltage regulation
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
What is the general power consumption rating of CPU CRT type and Flat type, Monitor,Printer, projector, Scanner?
what is meant by 3rd hormonics ?
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
What is current divider rule (cdr)?
Is the installation of the filter cloths necessary before spreading the gravels at the transformer yards?
why sometime we get electrical shock while touching the ballon of dish tv connection ? which we should not get.
why the check zone and main zone are used for Busbar Protn. scheem?
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
working of diesel generator ?
what kelvin's law ?
why the neutral line is not giving shock to us if we touch it ?
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
