what will happen if the secondary of current transformer
kept open....
- 11 Answers
- 15646 Views
- I also Faced
- E-Mail Answers
Answer Posted / bhanu satya prasad
if the secondary of the ct is open ,this condition will
stress ct and dangerously high voltage will be induced in
the secondary ,there may be a chance for sever hazards
| Is This Answer Correct ? | 54 Yes | 2 No |
Post New Answer View All Answers
Hi, This is Laila. I am selected for syndicate bank interview. Could you please share your views and the questions asked if you have faced the interview My email id is laila_honey09@yahoo.com Please send as fast as u can.Thank You Thanks... Laila.
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
can anyone give an idea about dia calculation in cold rolling mill
what is differnce btwen lll and lllg faults
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
what are all the components required to assemble solar panel other than pv cell?
What is a commutator?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
What are PLC leader logic program method
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
How to calculate the Efficiency of Chiller
The loads are connected with phase and ground then why current flow as the loads ?
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
i am completed my degree(B.E EEE) 2014 anychance to get electrical licence plz help me
