why does mA signal preferred for signal transmission?
- 12 Answers
- 21990 Views
- Emerson, I also Faced
- E-Mail Answers
Answer Posted / ibrahim s
mA Signal :-
1. Current measures remain same in any point of the signal
transmission line(no loss).
2. Less noise interference.
mV Signal:-
1. Voltage droup occurs(loss).
2. Noise interference is high.
So that mA signal is preferred over mV signal
| Is This Answer Correct ? | 29 Yes | 3 No |
Post New Answer View All Answers
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
I want to know the questions asked in ONGC interview(after being selected in the written exam) for Instrumentation branch.Kindly help.
what is scale factor of proximitor & unit of the vibration.
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
how do we commission inergen system?
Where is wet leg is used?
Definition of reverse and acting controllers:
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
Difference between ultra sonic flow meter
Explain the working of an enraf level gauge.
What is the meaning of wet leg
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
what are the selections available in configuring a burnout protection of a controller? thanks
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
