Which Programming software are use for Allen bradley PLC's?
- 16 Answers
- 22700 Views
- ADC, I also Faced
- E-Mail Answers
Answer Posted / ashish
rs 500
| Is This Answer Correct ? | 28 Yes | 16 No |
Post New Answer View All Answers
What is center gravity load in substation?
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
State magnitude criterion.
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
Why is remote backup preferred to local backup?
Why efficiency in thermal power plant is low?
What safety precaution are to be taken for avoiding electric hazards ?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
hi can anyone pls tell me the eee interview core questions asked in l&t
Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
I completed my BE EEE degree 2006 .... which license should i apply .... ?????
Transformer how to maintaince a check b check c check d check
