Answer Posted / vikash gupta
in case of ac e=-N d(phi)/dt
when in ac motor we applied dc,since in dc, fulx is always
constant,so rate of change of flux w.r.t. time is zero.so
there is no back emf which limits the extremly high
current,that's why due to high current AC Electrical Motor
is burnt.
Is This Answer Correct ? | 26 Yes | 8 No |
Post New Answer View All Answers
do anyone out there know where to find a compleete list on acronyms/abbreviations used in offshore electric engineering. MCB - Micro Circuit Breaker, MCCB-Mouldes Case Circuit Breaker, ELCB-Earth Lekage Circuit Breaker, ELMCB- etc.....
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
Electronic circuit
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
What will happen if the voltage in my house drops from 220V to any lower voltage?
DG SET BLOCK DIGRAM
10 Mtr Hight of Lighting Arrestar how much area coverd??
Please elaborate th´evenin’s theorem?
why core is useful for a transformer ?and also in its operation ?
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
What is primary and backup protection?
How cable from Kit-Kat to main switch, from starter to motor are designed?
what happens if dc supply is given and the remedies for it.
What is the purpose of stablization resistor in high impedance bus bar protection
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?